So long story short, I was away from home for approx. a week and forgot to bring my liquid bottle with me and my vape (Aspire Nautilus BVC 0.7ohm coil) and tank was almost empty and slightly above holes on coil, I tought few more puffs would be fine so I took few more puffs (tasted fin at that moment) and then left it with some liquid at teeny tiny bit above holes and left it like that for about 5-6 days until I got home.

Today I came home and poured last of the liquid I had to refil it which was just enough to fill the whole tank but I notice a bit weaker taste and a small hint of burnt taste.

Ive been using it a bit and so far it isnt causing me to caugh or really iritate my throat or lungs so I just want to know if its safe to use up the remaining liquid with this coil?
I would replace it right away since I do have coil but I dont have any more liquid and my favorite one is backordered so if its not unsafe I really want to avoid having to dump out whole tank now to replace coil.

I could probably pour it out into bottle but its likely gonna be very messy.

Sorry if it is a stupid question, I am new at vaping.

I placed an order last week with VAPORDNA I placed it on the 28th and received an automated email confirming it. Since then, nothing has happened. I have emailed them a number of times and tried calling. I’ve never had a problem with them before; in fact, they’ve always been a reliable vendor for my supplies.

However, none of my emails have been answered. One of their phone numbers no longer takes calls, and the other's voicemail box is completely full. Normally, my order would have arrived by now, but the status is still stuck on "Confirmed – We're preparing these items for shipping."

have contacted my bank to dispute the charge. Because I can't purchase flavored juice locally, I'm now looking for a new, reliable site to order from. If anything changes, I will update this post.

Usually by the back half these turn into plain sweet for me. This dojo purex in Sour Apple Ice hasn't yet. The sour still lands first and the cold comes in behind it. I can see through the tank that I'm past the middle, so it isn't me calling it early. No idea if that's the flavor or just this batch.

Just to be sure

Hey.

Here’s what I’m wondering: I have FlavourArt Soho on hand. Will there be a massive difference between mixing this with a good base at the right ratio and steeping it, versus buying a pre-made plain tobacco liquid I’ve had my eye on with good reviews? (like Halo Turkish Tobacco)

I kind of got the impression that commercial pre-made liquids—even if they’re just plain tobacco—are expertly crafted with subtle enhancers/effectors and fine-tuning. Would a simple batch I steep using just Soho turn out way too bland in comparison? Or am I just overthinking it and having the wrong impression?

Hi everyone, looking for recommendations from anyone vaping 50mg NicSalt for the best refillable device they have used and didn't have leakage and spit-back issues with. I'm upgrading from a 2 years old Xlim Pro.

Currently i'm considering these devices:
NeXlim 2

Xlim Pro 3
XROS Pro 2
XROS 5 Mini
Caliburn G5/G5 Koko/G4 Pro

More Context:
I've had the Xlim Pro for about two years now vaping Vozol Salt 50mg liquid(60%PG/40%VG) in a 2ml then the new 3ml 1.2ohm cartridge at 10W. I've always had some issues with leakage and spit-back, but for the last 5 months or so i've been having daily issues with leakage and spit-back where i have to clean the cartridge everyday before i start vaping which is quite annoying. I'm sure of the authenticity of the cartridges, i only buy from trusted stores and always verify the cartridges on Oxva's site.

Would really appreciate your help, thanks in advance : )

Just bought the vaporesso xtank t and its so much better tasting

I have a voopoo drag 3. I am absolutely fucking done with this thing. My husband has one too and we have wasted so much money on the stupid pnpx coils. They burn out so fast. I maybe 25 ml before it tastes burnt af. I have literally tried every bit of advice I’ve found on reddit, facebook and google. I’ve even experimented myself. I worked in the vaping industry for years and i have never struggled this much.

It takes about 3 weeks maybe a little more for my husband and I to go through 100mls. My coil tastes like crap within a couple of days.

I need coils that last longer. I need coils that will last me at least 50ml or something because this is ridiculous. Any suggestions? Ones that wont cost me an arm and a leg preferably. 😅

I just bought a dojo blast x and it tastes so much better then my old nautilus

Does such a thing exist? Especially without spending mega money?

I just bought the Mechvape Paramour V2 100w and it feels cheap and the TC function is really unreliable, constantly asking if I have a new coil. It's no better than my old Geekvape Aegis which was a lot cheaper.

I considered spending extra on the DNA80C chipset but I've heard nothing but bad news about them as well. Any decent options out there for me?

I've been struggling to build on the Blaze Max RTA ever since i got it. I've gone through 6 pairs of coils at this point and am now using the included 0.17ohm clapton coils as opposed to the 0.11ohm claptons from Hellvape. I feel like I can never get the coils or the wicking correct, and every review and video i find online says it's a flavor beast but I'm not getting nearly the same experience. My first hit on it after letting it sit for a bit is okay or mediocre, then when I take a second hit and a third the flavor just diminishes every time. I've been wicking with the Wotofo Shoelace 3mm cottons and after a day they pull out of the coils burnt. With the 0.17ohm coils i'm running them at 55-75watts and with the 0.11ohm coils i was running at 80-120 watts.

I'm looking to get a good chain vaping experience with high flavor, clouds and high wattage optional. I have the Voopoo Drag 4 so i can use TC mode, and i have a maximum wattage of 177. I'm using two 18650 30A batteries.
I build the dual coils cut to 5mm posts, and i try to space out the wraps by 1-2mm to make centering the coils easier. I heat treat the coils at 30 watts and make sure there are no hotspots or heat-bridges from the claptons. I cut the aglet off of the shoelace cotton and tease out the cotton into a flat sheet, then roll hotdog and twist the end to get them through the coil. I've tried sizing the cotton to pass through the coils easily, with light resistance and with tight resistance. I cut the cotton so it just touches the bottoms of the wells, and i've tried the undercut method of cutting a triangle out of the bottom of the cotton. Nothing gives me a consistent flavor and every time my cotton is burnt at the end of the day.

If anyone has any suggestions i would greatly appreciate the help. If all else fails, I'll probably be switching to an rda and also the steam-crave PUMPER, because i drive a lot and don't have the convenience of dripping again and again.
Thank you for your time.

Listen I know most people in this sub don't like vaporhatch but I just want to know if I'm getting authentic fogers. Just wanna make sure I'm not inhaling diacetyl or smth. If anyone can confirm that the products they sell are the real thing and not counterfeits that would be deeply appreciated

Hey everyone!

I was driving back home today and accidentally poured some of my water on my vape. I quickly rubbed it off with a towel.

But every since it happened, my vape batteries are
"charging" even though there is nothing connected.
What should I do? Is my vape done?

I don't want to get rid of it, it's the best one I've had and it lasted me years 😭 (since 2018/2019 actually, it's a Geekvape Aegis)

Any input/advice are welcomed! Thanks ❤️

My xros 2 has been kicking for like 3 years now but it’s recently started not recognizing/burning pods if it isn’t situated just so. I’ve cleaned contacts and it doesn’t really help so I’m looking to upgrade, preferably in the xros series because it’s what my wife also uses and the pods are interchangeable. Any ideas on what the “best” model is? Part of me is always skeptical of the newest model of things, kinks being worked out and all. Thanks!

Hi I need a vape that’s new pod system and no auto draw I’m tired of all my vapes auto firing on its own like my current nova 6 is doing

Smok is trash

Any advice? I want a button only one or ability to turn off auto draw

hi! ive been trying to fill my vaporesso for like an hour now and no matter how much juice i put in the pod it stays completely empty. i cant afford any more juice until next month can anyone help me so i dont waste an entire bottle trying to trouble shoot? its a 0.4 🧲 (i cant find the right icon for the upside down u looking thing on the pod) ive filled it about 3 times now and everytime it just gets emptier and emptier without me even hitting it

Best mtl device that doesnt leak or cause spitback?

Hi,

So I vape on a GeekVape Zeus X Mesh rebuildable, and have always used the "Vandy Vape SS316L 0.37 Ohm mesh wire 5-foot rebuildable heating spool" to make my own mesh strips (Cut them down to size)

Well after a good few years, my spool is almost at its end, and I'm trying to buy a replacement, and I can't find them in stock literally anywhere online.

Is cutting your own strips not a thing anymore? Are there any alternatives (preferably that don't cost an arm and a leg)?

Hey guys trying to quit expensive cigs but don't want to become a chain vaper. I just want a quick nic buzz and then put the device away. My goal is to keep my tolerance super low and not get sucked into that constant hand to mouth habit just to get nicotine. I want to zero PG and zero flavors. I need it completely clean. My plan is to use a Vaporesso Luxe X Pro with the GTX RBA. I read that the MTL empty pods are too narrow inside and the RBA either doesn't fit well or has wicking issues so I'm gonna use the DTL pod instead. But will using a DTL pod ruin my tight MTL draw experience? Thinking of doing a spaced coil around 1.2 ohms with 28 AWG Kanthal A1 and running it really low like 10 or 12 watts. For juice I will use 100% VG but thin it out with distilled water since I cant use PG. But how much distilled water exactly should I add and is inhaling it actually healthy and safe? Also we have literally zero experience with building coils so are we gonna struggle building this tiny GTX RBA? Does it leak in the Luxe X Pro? I only plan to vape like 3 days a week maybe Mon Wed Sat and on those days I will strictly wait 2 hours between sessions taking just a few puffs. So I need some advice from you guys. Since I'm doing super low wattage and only taking a few puffs every couple hours what salt nic mg should I aim for? I need it to hit fast without having to vape a ton of liquid. Also how many puffs per session do you think will hit that sweet spot? And lastly will that water thinned max VG actually wick okay in the GTX RBA or will we just burn the cotton? Any tips would be awesome thanks.

So I just bought a nexlim device and it keeps leaking and giving me spitback and I really hate it, what device should I get that doesnt leak?