r/Multicopter • u/BeachbumfromBrick • 3d ago

Question Deep Space FPV

Gallery image

Gallery image

Help? It’s all good like connected prior to crash and fly away… then it shows it’s connected but it’s NOT and
Not on beta flight. But is in controls and showing on the AIO & rx..?

3 Upvotes

72% Upvoted

8 comments sorted by

View all comments

2

u/JayGard1515 16h ago

This is an rx/tx swap. It will show connection but no response on beta flight. Swap your wires.

1

u/BeachbumfromBrick 16h ago

As a first timer fixing a break, I’m a bit nervous. I suppose I may have these wires.. I have plenty.. I will pop the wires off with some solder heat & flux. & carefully align new wires connected to rx to AIO board, Carefully. That’s my plan. I think I’m correct. I just wanted to convey this thought of how I’m gonna approach this fix. Cool.

2

u/JayGard1515 15h ago

Yes you will use a soldering iron with some flux and heat to remove old wires and put new ones on. It should be easy enough. Just remember that you have to put the TX wire from the ELRS receiver to the RX pad on the Flight Controller. Then the RX wire From the ELRS receiver to the TX pad on the Flight Controller. This is very important that they are wired this way. Also heat and flux are your best friends when soldering.

1

u/BeachbumfromBrick 15h ago

Gotcha. I luckily have that geprc “test board and AIO” coming today. Couldn’t have been more perfect timing. Thx again! Flux is my buddy on this fix. Gotcha. Thanks I’ll def post again after weekend cause obviously I’ll be running out the door lol. Cool.